Rc Edge 540
Published: October 12, 2026
1 downloadDíreach tar éis na híocaíochta, gheobhaidh tú do nasc íoslódála i ndearbhú an ordaithe, ar leathanach stádais an ordaithe agus trí ríomhphost.
An bhfuil ceist, tuairim nó gearán agat faoin táirge? Déan teagmháil go díreach leis an gcruthaitheoir tríd an gcnaipe “Contact creator” ag barr an leathanaigh seo.
This indoor Edge is a fun and quick project for the winter season. The fuselage is 3D-printed from ColorFabb LW-PLA at 65% flow. The infill used is specified in the name of each respective part. The wings and rudder are made from 6 mm Depron foam and reinforced with a 6 mm CFK tube. The plane is powered by a Racing Drone 2206 2300 KV motor on a 35 A ESC with a 3S 500 mAh battery and uses four 5 g servos.
I suggest reinforcing the motor plate with plywood.
The hinges are cut in along the marked lines, beveled at 45° on both sides, and then reinforced with packing tape.
Specs:
-Wingspan: 940 mm
-Length: 910 mm
-Weight: approx. 300 g
-Center of Gravity (CG): 90 mm behind the leading edge
Materials needed:
-6 mm Depron
-6 mm × 750 mm CFK tube
-2 mm × 2000 mm CFK rod (2 m)
-ColorFabb LW-PLA
Electronics:
-5 g servos (×4)
-2206 2300 KV motor
-35 A ESC
Flying video:
