Rc Edge 540
Published: October 12, 2026
1 downloadTuj post la pago vi ricevos vian elŝutan ligilon en via mendokonfirmo, en via mendostata paĝo kaj retpoŝte.
Ĉu vi havas demandojn, rimarkojn aŭ plendojn pri la produkto? Bonvolu kontakti la kreinton rekte per la butono „Contact creator“ supre de ĉi tiu paĝo.
This indoor Edge is a fun and quick project for the winter season. The fuselage is 3D-printed from ColorFabb LW-PLA at 65% flow. The infill used is specified in the name of each respective part. The wings and rudder are made from 6 mm Depron foam and reinforced with a 6 mm CFK tube. The plane is powered by a Racing Drone 2206 2300 KV motor on a 35 A ESC with a 3S 500 mAh battery and uses four 5 g servos.
I suggest reinforcing the motor plate with plywood.
The hinges are cut in along the marked lines, beveled at 45° on both sides, and then reinforced with packing tape.
Specs:
-Wingspan: 940 mm
-Length: 910 mm
-Weight: approx. 300 g
-Center of Gravity (CG): 90 mm behind the leading edge
Materials needed:
-6 mm Depron
-6 mm × 750 mm CFK tube
-2 mm × 2000 mm CFK rod (2 m)
-ColorFabb LW-PLA
Electronics:
-5 g servos (×4)
-2206 2300 KV motor
-35 A ESC
Flying video:
